Browse › Tech ›Electrical and chassis

Wiper woes. Anyone experiance

Started by JonB · Sep 25, 2010 · 5postsSMF 2010–26

JonBSep 25, 2010, 7:23 pm · #1

My wipers swipe twice on intermittant and don't work on any of the constant speeds.

Swapped the wiper motor, relay/amp, and time control. Always the same.

Took a multi to the switch, think it's good.

Anyone? I'm due for inspection by the end of the month - Thursday.

Help.

XanoSep 25, 2010, 7:25 pm · #2

time control unit.  my old s12 had similar problems.

Its a small box behind the passenger kick panel with a big ass connector with a # of wires.  mine was bad, swapped in one from a CA20 car and it worked fine.

ive got it chilling in the garage if you wanna figure out shipping from 61265 to your loc if there isnt one available.  I'd charge ya shipping only, since you contributed to the sites funding Tongue

MaxpowSep 26, 2010, 12:37 am · #3

inb4motorswap.

sam31183Sep 26, 2010, 1:57 am · #4
Maxpow on 12:37:44 AM / 26-Sep-10inb4motorswap.

I loled. Sounds like xano has you sorted though!
JonBSep 26, 2010, 2:45 am · #5
Maxpow on 12:37:44 AM / 26-Sep-10inb4motorswap.
Motor swap? I'd like that. But it's just not in the cards for a while.

I got this tick in my CA20, but the op is good and it's not down on power, I don't think. Found closed loop at idle to.

13B is sitting, waiting. Keep thinking blow through cause I don;t have the coin for a stand alone. Actually I don't have the coin for much of anything right now. Still working on on my Domestic V8.

Xano, you gots a PM.

Also, I'm kinda down cause I stepped on a toad. Had them outside for a few years. Tonight, one of the basters hopped at the same time I stepped. Stupid bastard. How do you train wild toads not to get stepped on? - You don't.