open diff

I\'m pretty sure I slightly bent my axle shaft when I hit a curb back in \'97.  The car makes a pretty good grumbling/rubbing noise at any speed above 50mph.  Obviously it\'s there at lower speeds, but it is quite obvious when you get up to speed.  

Anyway, my question is, does the \'84 200sx have the same rear end as it\'s predecessor?  My car has the CA20E with solid rear axle.  

Thanks,
Jon

yes

you hit the curb back in 97 and your just now doing something about this? hahaha....sorry.

you hit the curb back in 97 and your just now doing something about this? hahaha....sorry.

I\'ve been spending time on my Galant VR-4 rebuild and I\'m just getting this car drivable for my sister.  It was the \"loaner\" car in my family for a long time so I\'m the one that gets to repair everything on it.  

I just need to install my injectors, AFPR, fuel pump, and 6an line in the galant and I should be able to turn up the boost to 20psi on 91 octane.  I just built the engine with 8.1:1 compression Ross pistons, Eagle rods, lightened and knike edged (trailing edge) crankshaft.  I\'m running Crower stage 2 cams in it and a Mitsu 20g turbo.  Here\'s a pic of the engine before I had put it in.  

My goal for the GVR4 is 300 AWD HP on pump gas.

hey my 87 se has the stock diffs in it i do not like the open diffs wut other diffs will fit my car and do u have the part #

part # 123...search button.